Assembly Instructions

Parts needed: Wood base, Cork Pillar, Apple MagSafe charger, Apple Watch charger

Remove the clear film from the nano suction pad. (Using a piece of tape makes it easy.)

Place the MagSafe cable onto the newly exposed nano suction pad.

Insert the Apple Watch puck into the cork piece. It’s a tight fit, so you may need to massage it in.

Thread the USB end of the charging puck through the “mouth” of the dock.

Insert the cork piece into the wood base. This is also tight, but the cork will give enough to allow for a snug fit.

Press the cable into the cable channel on the bottom of the dock.

Remove the clear film from the bottom of the dock. (Again, tape is your friend.)

You're finished! *Note* If the micro-suction pads ever lose their stickiness, you can “clean” them with a piece of tape to remove dust, or more thoroughly with soapy water.